Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateGenie Cable & Drum Replacement: The Enterprise Owner’s Guide
We replace Genie-compatible cables and drums for Enterprise homeowners, and the installed job usually runs $130 – $250 for cable service, with drum swaps priced alongside it once we see the setup. Cable and drum failures are an emergency trade, so same-day and 24/7 emergency availability is real here – a snapped cable can drop a door or leave a vehicle sealed in. Most Enterprise owners find out the hard way: the door comes down crooked, one side sags, or a cable whips loose and the whole thing jams. It’s rarely gradual. It lets go.
Key takeaways:
- A frayed or snapped lift cable is a genuine danger – call us rather than test it.
- We work on Genie cables and drums across the model lines, matched to your door.
- Cable repair in Enterprise typically runs $130 – $250 installed.
- The price is quoted on the phone and holds at the door.
Which Genie Models This Applies To
Cable-and-drum systems are mechanical, so they aren’t tied to a single Genie opener series the way a remote or a logic board is. What matters is the door, not the opener model. Still, Genie openers show up across Enterprise on a lot of homes, and if you’re running a Genie chain or belt drive with a standard sectional door, the cable-and-drum setup on that door is what we’re replacing – not a Genie-branded part in most cases. The drum and cable are matched to your door’s height, weight, and track, so the “right part” depends on measurements, not just a logo.
Here’s how to identify what you’ve got before you call:
- Find the door label. Most sectional doors carry a sticker inside with the manufacturer and model. That plus the door width and height tells us the drum and cable spec.
- Measure the door. Height and width, to the inch. A 7-foot door and an 8-foot door take different cable lengths – this is the compatibility gotcha that trips up online buyers who order by opener brand alone.
- Note the opener. Genie chain, belt, or screw drive, and the model if you can read it off the unit. It helps us understand the door’s load, though it doesn’t change the cable spec.
On OEM versus aftermarket for Genie: the cable and drum are standard hardware, so a quality aftermarket cable matched to your door is a sound choice and often what we fit. We don’t claim to stock parts or carry them on a truck – we source the right cable and drum for your door, and we tell you which we’re using and why before we start. A quick note in fairness: Otto’s Garage Door Enterprise is an independent service provider, not affiliated with Genie. We’re fluent across LiftMaster and Chamberlain too, and we’ll work on whatever door you’ve got.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Signs Your Genie Cable & Drum Replacement Is Failing
Cables and drums wear together, so a failing drum usually means the cable is on its way out too. Watch for these:
- A snapped or dangling cable. The lift cable has parted or come off the drum, and the door may hang crooked or not move at all. This is the emergency case – don’t try to force the door.
- Frayed, kinked, or rusted cable. Strands are breaking or the cable is corroding. A frayed cable under tension can cut or whip when it fails, so it gets replaced, not nursed.
- Door sits crooked or binds on one side. One cable has stretched or slipped on its drum, so the two sides lift unevenly. You’ll see the gap at the floor.
- Cable jumping off the drum or grinding. The drum is worn or the cable is mis-seated, and it’s rubbing instead of winding clean. That grinding sound is metal on metal.
- Loud pop, then the door won’t lift. Often a cable letting go, occasionally a spring. Either way the door is now unsafe to operate and needs eyes on it.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
In Enterprise, cable repair runs $130 – $250 installed. Drum replacement is priced with it once we see whether the drum is worn, since cables and drums are commonly done together. The number depends on door height and weight, whether it’s one cable or both, and whether the drum needs swapping. You’ll get the price on the phone and it holds when we arrive – no revision at the door.
What the price covers: the matched cable and/or drum, the labor to install and tension it correctly, and a function check of the whole door before we leave. Every job carries our 90-Day Done Right Promise in writing on the invoice – if it’s not right, one call brings us back. Spring work, if it turns out that’s also involved, is separate and typically $180 – $340. We don’t quote a cable job and then invent charges.
DIY or Call Us?
We’ll be straight with you, because a cable under tension is not a weekend project. You can safely do a few things: look at the cable for fraying or rust, check that the door sits level at the floor, listen for grinding as it moves, and read the door label so you can tell us what you’ve got. That’s it. Once you’re dealing with a cable that’s snapped or a drum that needs re-seating, you’re working around stored tension that can whip and injure – a door is heavy and the cable is what holds it. That’s the point to stop and call.
If your Genie door in Enterprise has a failed cable or drum, we’ll quote it on the call and get out to you. Call (833) 620-7107 – live person, any hour.
FAQs
Lift cables and drums typically last many years, but in Enterprise’s dry desert climate the real enemy is dust and lack of lubrication – cables dry out, corrode, and fray faster on an unmaintained door. A cable that’s rusted or kinked is past saving. Call us and we’ll tell you honestly what’s left on yours before it lets go.
No – a frayed, kinked, or snapped cable gets replaced, not patched. A damaged cable under tension can fail without warning, and splicing it isn’t safe. We replace the cable and check the drum while we’re there, since they wear together. Call (833) 620-7107 for an exact quote – estimates are free.
Most single-door cable jobs are done within a couple of hours once we’re on site, and often same day for a failure. We’ll give you a realistic window on the call rather than a guess. The price is agreed before we start, so nothing changes when the job’s done.
We match the cable and drum to your door’s height, weight, and track, not just the opener brand – that’s where online orders go wrong. We measure and confirm the spec, tell you whether we’re fitting OEM or a quality aftermarket equivalent, and why. Call (833) 620-7107 and we’ll sort the right part for your door.
Have a Genie door in Enterprise that’s dropped, crooked, or making that grinding noise? Call (833) 620-7107 for a free estimate. A live person answers around the clock, we’ll quote the job on the call and hold that number when we get there, and every job is backed by our 90-Day Done Right Promise in writing. Proudly local, owner-operated, and verifiable address and license you can check before we ever pull up.
Written by the team at Otto’s Garage Door Enterprise, serving Enterprise and nearby areas.