A Otto's company - serving Enterprise, NV

Genie Cable & Drum Replacement in Enterprise, NV

Raised-panel steelRaised-panel steel
Carriage houseCarriage house
Modern flushModern flush
Full-view glassFull-view glass
LiftMaster openersLiftMaster openers
Chamberlain openersChamberlain openers
Every visit starts with

Full 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included

We have financing partners for your new garage door*On approved credit; ask us about your options

You get a price before we start. It does not change when the pro arrives.

Get your free estimate

Genie Cable & Drum Replacement: The Enterprise Owner’s Guide

We replace Genie-compatible cables and drums for Enterprise homeowners, and the installed job usually runs $130 – $250 for cable service, with drum swaps priced alongside it once we see the setup. Cable and drum failures are an emergency trade, so same-day and 24/7 emergency availability is real here – a snapped cable can drop a door or leave a vehicle sealed in. Most Enterprise owners find out the hard way: the door comes down crooked, one side sags, or a cable whips loose and the whole thing jams. It’s rarely gradual. It lets go.

Call (833) 620-7107

Key takeaways:

  • A frayed or snapped lift cable is a genuine danger – call us rather than test it.
  • We work on Genie cables and drums across the model lines, matched to your door.
  • Cable repair in Enterprise typically runs $130 – $250 installed.
  • The price is quoted on the phone and holds at the door.

Which Genie Models This Applies To

Cable-and-drum systems are mechanical, so they aren’t tied to a single Genie opener series the way a remote or a logic board is. What matters is the door, not the opener model. Still, Genie openers show up across Enterprise on a lot of homes, and if you’re running a Genie chain or belt drive with a standard sectional door, the cable-and-drum setup on that door is what we’re replacing – not a Genie-branded part in most cases. The drum and cable are matched to your door’s height, weight, and track, so the “right part” depends on measurements, not just a logo.

Here’s how to identify what you’ve got before you call:

  • Find the door label. Most sectional doors carry a sticker inside with the manufacturer and model. That plus the door width and height tells us the drum and cable spec.
  • Measure the door. Height and width, to the inch. A 7-foot door and an 8-foot door take different cable lengths – this is the compatibility gotcha that trips up online buyers who order by opener brand alone.
  • Note the opener. Genie chain, belt, or screw drive, and the model if you can read it off the unit. It helps us understand the door’s load, though it doesn’t change the cable spec.

On OEM versus aftermarket for Genie: the cable and drum are standard hardware, so a quality aftermarket cable matched to your door is a sound choice and often what we fit. We don’t claim to stock parts or carry them on a truck – we source the right cable and drum for your door, and we tell you which we’re using and why before we start. A quick note in fairness: Otto’s Garage Door Enterprise is an independent service provider, not affiliated with Genie. We’re fluent across LiftMaster and Chamberlain too, and we’ll work on whatever door you’ve got.

Explore

Styles & brands we work with

  • Raised-panel steel
  • Carriage house
  • Modern flush
  • Full-view glass
  • LiftMaster openers
  • Chamberlain openers

Signs Your Genie Cable & Drum Replacement Is Failing

Cables and drums wear together, so a failing drum usually means the cable is on its way out too. Watch for these:

  • A snapped or dangling cable. The lift cable has parted or come off the drum, and the door may hang crooked or not move at all. This is the emergency case – don’t try to force the door.
  • Frayed, kinked, or rusted cable. Strands are breaking or the cable is corroding. A frayed cable under tension can cut or whip when it fails, so it gets replaced, not nursed.
  • Door sits crooked or binds on one side. One cable has stretched or slipped on its drum, so the two sides lift unevenly. You’ll see the gap at the floor.
  • Cable jumping off the drum or grinding. The drum is worn or the cable is mis-seated, and it’s rubbing instead of winding clean. That grinding sound is metal on metal.
  • Loud pop, then the door won’t lift. Often a cable letting go, occasionally a spring. Either way the door is now unsafe to operate and needs eyes on it.
Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

Replacement Cost & What’s Included

In Enterprise, cable repair runs $130 – $250 installed. Drum replacement is priced with it once we see whether the drum is worn, since cables and drums are commonly done together. The number depends on door height and weight, whether it’s one cable or both, and whether the drum needs swapping. You’ll get the price on the phone and it holds when we arrive – no revision at the door.

What the price covers: the matched cable and/or drum, the labor to install and tension it correctly, and a function check of the whole door before we leave. Every job carries our 90-Day Done Right Promise in writing on the invoice – if it’s not right, one call brings us back. Spring work, if it turns out that’s also involved, is separate and typically $180 – $340. We don’t quote a cable job and then invent charges.

DIY or Call Us?

We’ll be straight with you, because a cable under tension is not a weekend project. You can safely do a few things: look at the cable for fraying or rust, check that the door sits level at the floor, listen for grinding as it moves, and read the door label so you can tell us what you’ve got. That’s it. Once you’re dealing with a cable that’s snapped or a drum that needs re-seating, you’re working around stored tension that can whip and injure – a door is heavy and the cable is what holds it. That’s the point to stop and call.

If your Genie door in Enterprise has a failed cable or drum, we’ll quote it on the call and get out to you. Call (833) 620-7107 – live person, any hour.

FAQs

Need Garage Door help nationwide? Licensed & insured · 30-60 min response · free estimates
Call (833) 620-7107
Local Service Coverage

Request a Free Estimate in Enterprise

Tell us what you need - Otto's Garage Door Enterprise responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Prefer to text? Send a Text
Call Now - 24/7 Dispatch